𓁟 host1.bitchan.one

questions that dont deserve a new thread a place for retards to converse thread theme: silly projects old thread >>3007669

⧖expiring ~16d0/7 kept2w ago

𓀐 @NGJ~uZ5o

⏱ 2w 👍 0

⬆ upvote 0

[⇥] sort oldest ⏱

⬆[⏱]₿⚠

👍👎✔

𓀐↩⛓⚠

[⇥] flip, oldest first

filter [-]
𓀐 @=HxrPNZ=: >>3011427 how come this sit has no Geritol section for all us old farts+ 1

⬆ upvote 0↩ reply 1

𓀐 @G6A8+ruz: >>3011497 Why are you old?+

⬆ upvote 0↩ reply 0

𓀐 @4w?ip9Lv: >>3011427 I bought some rubberized plates for my home gym, and the problem is that they have this strong rubber smell (If you've been to a gym, you know it). Is there a way to get rid of that? I've tried scrubbing it with hot soapy water, and it kinda worked, but the smell came back after a day or so.+

⬆ upvote 0↩ reply 0

𓀐 @zfWb-zsz: >>3011427 how difficult is it to chop through some steel square tube (50x50x1.5mm)? I tried to call a fab shop rather than buying something to cut metal with but the guy was so profoundly retarded that it's looking more worth to just do it myself than deal with someone who spends all day inhaling fumes I've worked with an angle grinder but I think due to how accurate I need to be here I might have to get a chop saw or something thereabouts is it completely necessary to go and buy more power too…+

⬆ upvote 0↩ reply 0

𓀐 @rXBGS5?n: >>3011427 If I'm a poorfag who cannot afford a dentist's visit and I have the beginnings of a cavity on one of my molars. What's the best way to do a DIY filling until I can afford to have it done properly? Would sterilizing it with alcohol or hydrogen peroxide, then applying a drop of super glue work? I read that this is a bad idea because bacteria can (and will eventually) infiltrate under the super glue, and that the tooth will continue to deteriorate underneath, but I don't have a lot of op…+

⬆ upvote 0↩ reply 0

𓀐 @_QNft56X: >>3011427 I'm trying to expand the mortice of our aluminum doors so that I can insert a Zigbee sensor inside to sense if the doors are locked, but it seems I'm not using the correct tool for the job. First attempt was drilling (as evidenced by the two holes), the idea being to drill multiple holes then snap the remainder off, but realized that it's a double-layer of aluminum which took long to drill into, and I already broke one drill bit trying this out. Next attempt was a cut-off tool with a…+

⬆ upvote 0↩ reply 0